- Remove power from the board
- Change Jumper/DIP switch settings, to enter recovery/forced-download mode:
Name | Link / Switch | State |
---|---|---|
Auto Power up | Link 1-2 / Switch 1 | closed / ON |
Recovery | Link 3-4 / Switch 2 | closed / ON |
Fastboot | Link 5-6 / Switch 3 | open / OFF |
- Apply power to the board using 96Boards compliant power supply
- Insert USB Type-C cable (OTG port) to the board, and connect the other end to your Linux PC
- Check whether there is a device node “/dev/ttyUSBx”. If there is, it means your PC has detected the target board; If there is not, try to repeat previous steps.